• Port Checker Download

The HC-05 Bluetooth Serial Port module works different from HC-06 (JY MCU). Firmata runs at 57600 baud, you'll need to reconfigure the module before making a connection with Johnny-Five, this is done by sending AT commands to the module.Step 1: Connect the HC-05 module to the Arduino for configurationWe will program the Arduino to send AT commands to the module to configure it via a SoftwareSerial connection. Wire the TX and RX pins of your module to your Arduino. They need wired in a crossover configuration, so from the module to the Arduino wire TX to pin 10 and RX to pin 11.Then upload the following Sketch to your Arduino which creates a connection between the Arduino's serial port and the HC-05. Modify the ROBOTNAME and the BLUETOOTHSPEED values before uploading if you want a custom name or have changed the baudrate before. HC-05 has defaults baudrate (38400).To put the HC-05 in AT commands mode you must connect the KEY pin in an arduino pin (I use pin 9) this is because this module works different.

Port Checker Download

( 01:06 PM)robynk Wrote: You are not allowed to view links. Or to view.here is a complete backup of my 2 dinYou are not allowed to view links. Or to view.You are not allowed to view links. Or to view.You are not allowed to view links. Or to view.You are not allowed to view links.

Or to view.it has johnnygt multi data zip 320x240 480x234 480x272 800x480meggaduck99 australia r19,1 maps.robynkHelp, downloaded and installed ok map works but unit cant find satelites but is ok with original mapping. As NRT suggested you probably have the wrong baud/port settings,port=1baud=4800orport=2baud=57600seem to be common chinese settingschange these in the sys.txt file,open with note pad and save when finishedtry deleting the SAVE folder in the root dir,dont worry primo will make a new one,pain in the butt to go through the set up again,i knowtry this downloadYou are not allowed to view links. Or to view.put on the root dir of the card and change the nav path to-primo v2.0/baud+port checker and run the program,it will show you what the actual figures are.or you can check the old gps programyou were running,it may have the numbers there.robynk.